Technical data 3
TL80 29
3.9.2 Consumable specifications
Stipulated consumables for Central Europe
Application
Code designation
acc. to Bi
1)
Designation
Specification,
standards, quality
Remarks
Engine -- Diesel fuel EN 590
ASTM D975 1-D / 2-D
Before using RME fuels
(rape oil methyl ester), it is
essential to consult your
responsible Terex dealer for
further details.
Engine EO 1540 A Engine oil SAE 15W-40
API CH-4 or CI-4
ACEA E3 / E4
See also engine manufacturer’s
instructions
Hydraulic system HYD 1040
Hydraulic oil or
multi-grade
engine oil
HVLP 46
or
SAE 10W-40
The following viscosity limit
values must be kept (according
to ASTM 445)
at 100 °C min. 8 mm
2
/s (cSt)
at -10 °C approx. 1,500 mm
2
/s (cSt)
BIO-E-HYD-HEES
Bio-degradable
hydraulic oil
based on
synthetic ester
Filling according to
customer
specifications. Brand
label on machine.
Do not mix bio-
degradable oils from
different
manufacturers.
The same viscosity values apply
as for mineral hydraulic oils.
When changing from
mineral to biodegradable
hydraulic oils, the tank and
hydraulic system must be
completely drained, cleaned and
flushed.
For further details before
changing oils, please consult
your responsible Terex dealer.
Axles GO 90 LS Gearbox oil SAE 85W-90LS
API-GL 5
Alternative recommendations
SAE 90LS
SAE 80W-90LS
Lubricating points MPG-A
Multi-purpose,
lithium-soap
based grease
K2K-30
DIN 51825
Brake ATF Brake oil ATF
Type A Suffix A
Dexron-IID
Cooler
Mixture of water,
additives and
glycol
Machine
damage
due to incorrect
coolant and mix
proportions.
Observe the
information on
the cooling
system given in
the engine
manufacturer's
Operating and
Maintenance
Manual.
The antifreeze is factory-set to
approx. -25 °C.
1) In conformity with the regulation lubricants of the Main Association of the German Building Industry e.V.
(Bi).
To Next Page
Loading...
