Rev. A
Name Min Max Severity Description
ing#Motor Controller
Motor Over Temperature Er-
ror#Motor Controller
Error
Negative Limit Switch Sta-
tus#Motor Controller
Error
Network Video Replication Warn-
ing
Warning
No Connection To NTP Dae-
mon#ET2
Error >Unable to establish connection to the local NTP daemon
No Connection To NTP Dae-
mon#HK
Error >Unable to establish connection to the local NTP daemon
No Transmission Sectors Defined
Warning
Warning
Sector transmission is enabled while no transmission sectors
are defined
No valid GPS data Error No valid GPS data
Over Voltage Error#Motor Control-
ler
Error
Over-Current Error#Motor Control-
ler
Error
Parameter Change Log Disk Limit
Reached
Error
Indicates that the amount of disk space allocated to the Parame-
ter Change Log has been used up
Plot Publisher Input Link#Air Error Could not connect to surface data input source.
Plot Publisher Input Link#Surface Error Could not connect to surface data input source.
PlotCombiner Input Link#Air Error Could not connect to data input source #Air.
PlotCombiner Input Link#Surface Error Could not connect to data input source #Surface.
PlotCombiner Performance De-
creased
Error Input plot older than latest output plot
PlotServer Overload#Air Error The number of received plots from HDL PEX is to big.
Positive Limit Switch Status#Motor
Controller
Error
Profile Unsaved Warning Warning
Indicates that changes were made to current profile that are not
yet saved
PSAT Calibration Data Not Match-
ing SSPA Error
Error
Stored calibration data does not match installed SSPA, rerun
PSAT calibration
PSAT Calibration Failed Error Error PSAT calibration failed, rerun PSAT calibration for this profile
To Next Page
Loading...
