4-10 | Cyber Hardened IBUC 2, IBUC 2e, IBUC 2G, IBUC R, IBUC G Operations Manual: Operations
If your reading does not match your expected level, first verify that the Cyber
Hardened IBUC 2, IBUC 2e, IBUC 2G, IBUC R or IBUC G is receiving the
proper input level.
3. If the input is at the correct level, use the command TPT on page C-43 to modify
the attenuation to set the output to the expected level.
4. If, after setting the output to your expected level, you are still having transmission
problems, check the flexible waveguide and antenna feed for obstructions. Also
check the alignment of the antenna.
To Next Page
Loading...
