6.4.5 Light
Press the SET key 12th time to select light unit (lux, fc, w/m2);Default
is w/m2.
6.4.6 Temperature
Press the SET key 13
th
time to select in/outdoor temperature unit,
degree C digits will start flashing, press the WIND/+ or PRESSURE/-
key to select unit C (as F is the default mode).
- In normal mode, press the TEMP. key to view wind Chill, Heat Index,
Dew Point Temperature. Pressing the TEMP. key for 5 seconds, will
register new transmitter.
Note: every 60 seconds the unit will measure indoor temperature,
indoor humidity and pressure. If the temperature is lower than minimum
range, it will display --.-, if it is higher than highest range, will display -
-.-.
6.4.7 Wind speed
Press the SET key 14th to select wind speed unit ( km/h, mph, knots,
m/s, bft ) – the default mode is km/h.
- In normal mode, press and release the WIND/+ key to view the wind,
gust and wind direction.
To Next Page
Loading...
