The sensor array may have initiated properly and
the data is registered by the console as invalid, and
the console must be reset. Press the reset button
as described in Section 5.2.
With an open-ended paperclip, press the reset
button for 3 seconds to completely discharge the
voltage.
Take out the batteries and wait one minute, while
covering the solar panel to drain the voltage.
Put batteries back in and resync the console with
the sensor array about 10 feet away.
The LED next to the battery compartment will flash
every 16 seconds. If the LED is not flashing every
16 seconds…
Replace the batteries in the outside sensor array.
If the batteries were recently replaced, check the
polarity. If the sensor is flashing every 16 seconds,
proceed to the next step.
There may be a temporary loss of communication
due to reception loss related to interference or other
To Next Page
Loading...
Need help?
General
