6) Wind direction offset calibrated (adjust by degree)
7) Wind speed factor adjust, default 100% (range 50% to 150%)
8) Rain factor adjust, default 100% (range 50% to 150%)
6.8 Other Features
6.8.1 Factory Reset/Clear Memory
To restore the console to factory default, perform the following steps:
1. Remove the power from the console by removing the batteries
and disconnecting the AC adapter.
2. Apply power by connecting the AC adapter.
3. Wait for all of the segments to appear on the screen. Press and
hold the WIND/+ and PRESSURE/- keys at the same time until
the console power up sequence is complete (about 5 seconds).
4. Replace the batteries.
6.8.2 Register New Transmitter
Press and hold the LIGHT /SNOOZE button for 5 seconds, and the
console will re-register the wireless sensor.
6.8.3 Backlight Operation
1) With AC adaptor.
The backlight can only be continuously on when the AC adapter is
permanently on. When the AC adapter is disconnected, the backlight
can be temporarily turned on.
Press the LIGHT SNOOZE key to adjust the brightness between High,
Low and Off.
To Next Page
Loading...
Need help?
General
