10 Alarms
10.1 Alarm list
Display of alarms
A summary of all triggered alarms and system warnings is displayed. Unread
alarms and system warnings are shown in bold.
The display can be filtered according to the following characteristics:
• By measuring point group/measuring point: click on the checkbox in front
of the measuring point group/measuring point.
• By date/time: click on the start date/end date and select the start
date/start time and end date/end time.
Detailed information on alarms
Click on the icon to display more information.
On displaying the detailed information, the alarm message/system warning is
marked as "read" and the alarm counter is marked down.
Click on the Mark all as read button to mark all alerts as "read".
10.2 Alarm settings
Creating and displaying alarm settings
• Click on the + New alarm setting button to create a new alarm setting.
Existing alarm settings are displayed below the button.
• Click on the title of an alarm setting to display it.
Configuring and editing a displayed alarm setting
The following settings can be defined and edited:
• Title: designation of the alarm setting (required field).
• Measuring points: Measuring point group/measuring point which is to
be monitored. Click on the checkbox in front of the measuring point
group/measuring point.
• Alarm limit value 1 and 2: Different limit value ranges which can be
defined for different periods.
• Upper limit, lower limit: Are values which are to be monitored.
• Alarm delay: Minimum duration of a limit value violation before an alarm
is triggered.
To Next Page
Loading...
Need help?
General
