• Day communication cycle and Night communication cycle: interval at
which readings are transmitted to the Testo Cloud. Select the start time
for the day communication cycle and the night communication cycle. Set
the communication cycle using the slide control.
• Channel name: designation of the measurement channel (required
field). Condition at delivery: Model_Serial number_Channel number
• Select unit: unit in which the readings are displayed.
• Select sensor type (only for model T2, T3): sensor type used by the
measurement channel.
• Save: click on the button to save the settings.
• Deactivate or Activate: click on the button in order to deactivate or
activate measurement channels or WiFi data loggers.
• Remove: click on the button in order to log WiFi data loggers off the
system.
11.7 Firmware updates
A list with available firmware updates for the WiFi data loggers is displayed.
Firmware updates can be installed on the data loggers via WiFi.
• Click on the Activate button to install a firmware update.
To Next Page
Loading...
