during the next communication cycle. Alternatively: Initiate data transmission
manually by pressing the control key on the WiFi data logger.
The WiFi data logger is displaying the warning message Err AccountID,
what can I do?
The AccountID contained in the configuration file is not valid.
Use the Quick Start Guide to create a new configuration file and save this onto
the WiFi data logger.
The WiFi data logger is displaying the warning message no AccountID,
what can I do?
There is no AccountID in the configuration file.
Use the Quick Start Guide to create a new configuration file and save this onto
the WiFi data logger.
The WiFi data logger is displaying the warning message no License, what
can I do?
The WiFi data logger cannot be logged on because the number of WiFi data
loggers permitted to log on has been exceeded or your testo Saveris 2 licence
has expired.
Log off another WiFi data logger, extend or renew your testo Saveris 2 licence.
The WiFi data logger is displaying the warning message not Active, what
can I do?
The WiFi data logger has been deactivated. It is not storing, and therefore not
sending, any measurement data to the Testo Cloud.
Activate the WiFi data logger (under Configuration --> WiFi data logger) when
the WiFi data logger needs to store and send measurement data again.
To Next Page
Loading...
