front end or by holding down the control key (>30 sec.). If the control key is
pressed by mistake during initial commissioning, hotspot mode can be cancelled
by briefly removing the batteries.
Caution
When configuring the loggers using the testo Saveris 2 App, the
smartphone is converted to an access point, and any default access
point settings are changed. After finishing the configuration, these
may need to be adjusted again manually.
Network analysis
Use the network analysis to analyze your WLAN network in advance in order to
check the requirements for operating the testo Saveris 2 loggers correctly.
You can also optionally create and send status reports.
Please note that, due to IOS system limitations, the logger
commissioning and network analysis can only be carried out on
Android devices
Alarms
With the testo App, you can receive all Saveris 2 push alerts and see an
overview.
In order to be able to establish a connection, you need a tablet or
smartphone with the testo App already installed on it.
You can get the App for iOS instruments in the App Store or for
Android instruments in the Play Store.
Compatability
Requires iOS 8.3 or later/Android 4.3 or later
Push alerts will not be forwarded if the smartphone is switched off or
if the provider service is unavailable.
To Next Page
Loading...
Need help?
General
