4.
Use
the printhead-adjustment lever to
move the printhead away from the platen.
5.
To
load paper through
tile
back paper
path,
a.
Put the paper supply
in
back
of
the
printer.
b.
Insert the paper, with the side to
be
printed facing down, into the paper
path at the back
of
the printer until the
paper appears at the platen. Align the
paper
so
that it does not rub against
the sides of the paper path.
c.
Go
to step
7.
6.
To
load paper through the
bottom
path,
a.
Put the paper supply under the table or
stand.
b.
Insert the paper, with the side to
be
printed facing forward, into the bottom
paper path
until the paper appears at
the platen. Align the paper
so
that
it
does not rub against the sides
of
the
table slot or the sides
of
the bottom
paper path.
c.
Go
to step
7.
7.
Loosen the locking lever
on
the right
tractor and adjust the tractor to accept
the paper width.
8.
Put the paper
in
both tractors with the
holes
on
the tractor pins. Make sure you
place corresponding holes
on
correspond-
ing pins.
9.
Close
the tractor covers and move the
right tractor to pull the paper tight across
the
platen. Then tighten the locking lever.
10.
Check the alignment
of
the paper supply
with the paper path. Paper must not
touch either side
of
the path.
11.
Return the printhead
to
its original
pOSi-
tion (step
4)
using the printhead adjust-
ment lever.
2-6
NOTE
To prevent possible damage to the
printhead and platen, do
not
operate
the printer without a ribbon and paper,
or beyond the width
of
the paper.
2.6
CONNECTING THE POWER CABLE
Make sure that the printer is adequately grounded
by
plugging the power cable into a three-wire
power receptacle.
CAUTION
Refer
to
the
identification
label
on
the
back
of
your
printer
for
correct
voltage
levels.
An
incorrect
voltage
can
cause
damage
to
the
printer.
~
TEXAS
INSTRUMENTS
TEMPLE.
TEXAS
"'PRINTER
M,t,OEINUSA
=!:~~~.O;~
~~~:.r:..
AMPS:
'/.'1
PHASES:
1
WATTS;.
2222627-13
Figure 2-10.
Power
Switch
and
Identification
Label
1.
Set the power switch
to
the OFF position.
2. Connect the power cable to the printer
by
firmly pushing the female end
of
the cable
into the printer.
3. Connect the other end
of
the power cable
to
the proper three-wire receptacle.
To Next Page
Loading...