Texas Instruments 880 - Menu

Table 3-1. Configuration Codes (concluded)
Configuration Code* Definition
Miscellaneous
Codes
(not limited)
81 Execute escape sequences
83 Send DC1 when READY; DC3 when BUSY
84 Do LF and CR on reception of LF
85 Do LF and CR on reception of CR
87 Print all control characters
8A
Enable BUSY on pin 20 (DTR) of RS-232 connector
8B Do CR after LF, VT, DC2
8C Enable vertical raster graphics (see Chapter 6)
93 Set absolute line length to 8 inches (see Table 3-2)
99 Enable horizontal raster graphics (see Chapter 6)
9A SO selects expanded print for one line
9B Power-up on line
9C Select 256-byte input buffer
*Underlined codes
are the default codes.
Table 3-2. Characters Per Line (CPL)
3.3.3 Character Set Report and Menu
By printing the character set menu you can
Standard Pitch
Double-Wide Pitch
choose any of the optional character set ROMs
you have installed. See Figure 3-5.
Code
93
Code 93 Code 93 Code 93
ON OFF
ON OFF
NOTE
CPI CPL CPI
CPL CPI CPL CPI CPL
If
no optional character set ROM is
installed, the printer will not print the
10
80 10 132
5 40 5 66
character set report or character set
menu.
12 96 12
158 6 48 6 79
16% 132 16% 220
8% 66 8%
110
3-13