Follow these steps
to
print the configl.lration report:
1.
Open
the printhead door.
2.
Press
the
Command
key.
The
Normal
indicator turns
off
and
the
Command
indi-
cator turns on.
3.
Press
the
Menu
key.
The
Menu
indicator
turns on. The printer
immediately prints a
form report.
4.
Press
the
Accept
key.
The
printer immedi-
ately prints a configuration report.
The
fol-
lowing
example
shows
a
typical
configuration report.
CNFG:
14;
27;
36;
41;
81;
9B
3.3.2.1
Configuration
Codes. The numbers
listed in the configuration report
are
codes for the
various configuration features. Configuration
codes
are
listed in Tables
3-1
and 3-2. The
numbers
in
the configuration report
are
for the fol-
lowing
configuration features.
• 1st code: Communication mode
• 2nd code:
Baud
rate
• 3rd code: Parity
•
•
4th code: National language version
Sth
code: Miscellaneous features (More
than one
of
these can be
selected.)
3.3.2.2
Changing
Configuration
Codes.
Follow this procedure
to
print the configuration
menu and make new configuration
selections:
1.
After
printing a configuration report
as
described
in
paragraph
3.3.2,
"Configuration
Report and
Menu,"
press the
Change
key. The printer
begins to
list the configuration menu by
printing the
currently selected code
for
communication mode,
as
shown below.
COMM MODE
= 14-0N
ON
means the feature is selected (ac-
tive).
OFF
means the feature
is
not
selected (inactive).
2.
Press
the
Change
key. The printer turns
off
code
14
and shows the next com-
munication mode code, which in this
case
is
1S.
(The codes appear in numeri-
cal order.)
COMM MODE = 14-0N 14-0FF 1S-0N
3.
Press
the
Accept
key to select configu-
ration code
1S.
(Or, you can keep press-
ing the
Change
key, and the other
configuration code choices
will
be
listed
until
you press the
Accept
key
to
select
one.) The printer
now
underlines your
choice for communication mode and
lists the currently selected baud rate
code,
as
shown below.
COMM MODE
= 14-0N 14-0FF 1S-0N
BAUD RATE = 27-0N
4.
Press
the
Change
key. The printer turns
off
code
27
and shows the next choice
for baud rate, which
is
28,
as
shown in
the
following example.
COMM MODE
= 14-0N 14-0FF 1S-0N
BAUD RATE = 27-0N 27-0FF 28-0N
3-9
To Next Page
Loading...