A.1 INTRODUCTION
This appendix provides instructions for connect-
ing the Model
880
Printer
to
the TI Business Sys-
tem 200,
300,
600, or
800.
Refer
to
the following
documents for specific programming or other
information regarding the printer or individual sys-
tem interfaces.
• Model 880 Printer Maintenance Manual
(TI
Part No. 2222628-0001)
•
•
•
•
•
•
•
System
200 General Description Manual
(TI Part No. 2533251-9701)
System
200 Maintenance Manual (TI Part
No.
2533252-9701
)
System
300 General Description Manual
(TI
Part No. 2533308-9701)
System
300 Maintenance Manual (TI Part
No.
2533309-9701)
Model 990/
10A
General Description
Manual
(TI
Part No.
2302633-9701
)
C1402
Installation and Operation Manual
(TI Part No.
2263895-9701
)
C1403
Installation and Operation Manual
(TI
Part No. 2263897-9701)
Appendix
A
TI
Business Systems
Interface Instructions
A.2
INTERFACE
INSTRUCTIONS
Use the control panel
to
enter the menu mode
and
print
the configuration report. Select baud
rate code 27. Refer
to
the instructions in Section
3.3.2,
"Configuration
Report and
Menu."
Both
logic and chassis ground should
be
isolated
for
Business System use. Refer
to
Appendix D,
"Power
Requirements and
Grounding,"
for
an
explanation
of
how
to
change grounds.
Refer
to
Sections 2 and 3
of
this manual for printer
installation and operation procedures.
CAUTION
Be
sure
to
tighten
the
securing
screws
on
all
cable
connectors
to
provide
proper
cable
grounding
and
shielding.
Failure
to
securely
fasten
these
connectors
could
result
in
errors
in
the
data
transmit-
ted
to
the
printer
andlor
noncom-
pliance
with
FCC
regulations.
A.2.1 Business
System
200/300
and
931/940
Terminals
Use the following procedure
to
connect the Model
880
Printer
to
the Business System 200/300 or the
931/940 Terminal.
1.
Attach connector
Pl
of
the interface
cable
(TI
Part No. 2230504-0001)
to
the
AUX
1
port
at the rear
of
the terminal.
A-1
To Next Page
Loading...