This manual describes the installation, operation,
limited maintenance, and software control
of
the
Texas Instruments
OMNI 800* Model 880 and
Model
880
DP
Printers. All references in this
manual
to
the Model
880
Printer include the Model
880
DP
Printer, unless otherwise specified.
Section 1, INTRODUCTION - Provides a short
summary
of
the Model 880 Printer features, and
shows sample printouts.
Section 2, INSTALLATION - Describes
how
to
install and prepare the printer
for
operation.
Section 3, CONTROL PANEL OPERATION
Describes how to use the operator panel to select
printer features and printer configuration.
Section 4, PROBLEM ANALYSIS - Describes the
Test mode, status report, defines diagnostic error
codes, and outlines troubleshooting procedures.
Section
5,
SOFTWARE
COMMANDS
Describes software control
of
the printer, including
control characters and
escape
sequences.
Section
6,
RASTER GRAPHICS - Describes
. escape sequences and control characters for hori-
zontal and vertical raster graphics.
Section
7,
COMMUNICATION INTERFACES
Describes serial and parallel communication inter-
faces.
* Trademark
of
Texas Instruments Incorporated.
Preface
The appendixes discuss:
A
-
TI
Business Systems
B - Maintenance
C - Control and Character
Codes
D - Power Requirements
and
Grounding
E
- Options and Accessories
F
- Specifications
Other
Documents
The
document
below
provides
additional
infor-
mation
forthe
Model
880 Printer:
Mode/BBO
Printer
Maintenance Manua/
(TI Part No. 2222628-0001)
To receive a copy, send a request (purchase order)
to:
Texas Instruments Incorporated
Terminal
Spare Parts -
MIS
7793
P.O. Box
1444
Houston, Texas
77251
iii
To Next Page
Loading...