5.
Press
the
Accept
key to select
12
CPI.
(Or,
you
can
keep
pressing the Change
key,
and the other
CPI
choices will
be
listed until
you
press
the
Accept
key to select one.)
The printer now underlines your choice for
CPI
and lists the current
LPI
(lines per inch)
selection,
as
shown
in
this example.
FONT = DRAFT ENHANCED
CPI
=
10
12
LPI=
6
6.
Press
the Change
key.
The printer now
shows the next choice for
LPI,
which
is
8
lines
per inch,
as
shown below.
FONT
= DRAFT ENHANCED
CPI
=
10
12
LPI=
6
8-
7.
Press
the
Accept
key to select 8
LPI.
(Or,
you
can
keep
pressing the Change
key,
. and the other
LPI
choices will
be
listed until
you
press
the
Accept
key to select one.)
The printer now underlines your choice for
LPI
and
lists the current state of the perfor-
ation skip feature,
as
shown in this
example.
FONT = DRAFT ENHANCED
CPI=
10 12
LPI
= 6 8
PERFSKIP =
OFF
8.
Press
the Change
key.
The printer now
shows the other choice for the perforation
skip feature,
as
in
the following example.
FONT = DRAFT ENHANCED
CPI
=
10
12
LPI=
6 8
PERFSKIP =
OFF
ON
9.
Press
the
Accept
key
to
turn
on
the perfor-
ation skip feature. The printer underlines
your choice and prints a new form report
based
on
the four selections
you
just made,
as
shown below.
FORM:
PRTFEA
= H;
FONT
= ENHANCED;
CPI
=
12;LPI
=8
LM =
001;
RM
=
158;
TM =
002;
8M
=
086;
FL
=
088;
PERFSKIP
=
ON
10.
Press
the
Normal
key to accept the new
form report features and return to the nor-
mal
mode or
press
the
Accept
key
to
accept the new form report and print the
configuration report.
NOTE
Compare this form report with the origi-
nal
form report and notice thatincreas-
ing the
CPI
from
10
to
12
changes the
RM
from
132
to
158.
Increasing the
LPI
from 6 to 8 and activating the perfora-
tion-skip feature changes the
8M
from
66
to
86
and the
FL
from
66
to
88.
Changing vertical and horizontal pitch
causes
the right and bottom margin
numbers and the form length number
to
change
as
the printer maintains the
same
form
size.
Activating the perfora-
tion-skip feature changes the TM from
001
to
002
and the
8M
from
088
to
086.
See
Table
5-9
for more information
regarding margins and line lengths.
To Next Page
Loading...