Texas Instruments 880 - Page 95

A
Accept Key ....................... 2-8, 3-3, 3-5-3-11,
3-14-3-16,3-18,4-1,4-2
ACK ............................. 5-1,7-3,7-6, C-1, F-3
Alternate Character Sets .......... 1-2,3-15-3-18,
5-6-5-10
Applications Controller Board ............... 4-2, 5-7
Audible Tone .................................... 2-7,5-2
B
Backspace (BS) .......................... 5-1,5-2, C-1
Barberpole Test ........................... 2-8,4-1,4-5
Battery Failure ........................................ 4-3
Baud
Rate ................ 3-1,3-8-3-10,3-12,3-18,
4-4, A-1
BEL ......................................... 5-1,5-2, C-1
BUSY ........................................... 7-1-7-6
C
Carbon Copies ....................................... F-2
Carriage Movement Error .............. 3-2, 4-3, 4-5,
7-6,
F-2
Carriage Return (CR) ....... 3-13,5-1,5-2,6-5, C-1
Change Key ...... 2-8,3-2-3-5,3-14-3-16,3-18,
4-1,4-2
Character
Set Designation ......... 3-1,3-15,3-18,
4-2,5-10
Character Set Invocation .......................... 5-9
Character
Set Report ... 3-1,3-4,3-13-3-15,3-17
Character Set ROMs................. 3-13,3-14, E-1
Character Sets .......... 3-13-3-16,5-1,5-6-5-10
Chassis Ground .......................... 7-5, A-1, 0-2
Clear to Send (CB) .................................. 7-4
Command
Indicator .................. 3-1-3-4,3-15,
4-1,4-2
Command Key
.............. 3-1 - 3-5, 3-9, 3-15, 4-1
Command Mode .............................. 3-1-3-4
Configuration Code ................. 3-9-3-13,3-18,
4-4-4-6,5-7,5-9,6-1,7-1,7-4,7-5, C-3
Index
Configuration Report ............ 3-1, 3-2, 3-8, 3-11,
4-5,A-1·
Control Characters .............. 5-1-5-3,5-7-5-9,
C-3, C-4
o
Data Cable ................................. 2-1,2-9,4-5
Data Set Ready (CC) ................................ 7-4
Data Terminal Ready
(CD) ......................... 7-4
DCD ............................................... 4-5, 4-6
Default Features
........................ 3-18, 5-4, 5-6
DEMAND
............................ 7-3, 7-5, 7-6, F-3
Device Control (DC) ............ 3-13,5-1-5-3, C-1
OLE ............................................... 5-1, C-1
Double-Density Graphics .......................... 6-5
Double Wide Pitch (Expanded Print)
..... 3-13, 5-6
Draft Font
................. 1-1, 1-2, 3-6, 3-7, 5-3, F-1
DSR ............................................... 4-5, 4-6
E
Earth Ground ....................... 2-7,7-4,0-1,0-2
EIA ...................................................... F-2
Eight-Bit Data ............................. 5-9,6-1, 7-3
Electrostatic Discharge
....................... 2-2, 4-3
End of Message (EM) ................... 5-1,5-3, C-1
End of Transmission (EOT) ................. 5-1, 5-2,
6-5,
C-1
Enhanced Font ........... 1-1,1-2,3-6,3-7,5-3, F-1
Enquiry (ENO) ................. 5-1, 5-2, 6-4, 6-5, C-1
Error Codes .................................... 4-2-4-4
Error Indicator .................................. 3-2,4-5
Escape Sequences .............. 5-3-5-6,5-9,5-10,
6-2, E-1
Expanded Print ................................ 3-13,5-6
Expansion Buffer
.................................... 4-3
F
FAULT-
................................................ 7-6
Fonts
................... 1-1,1-2,3-1,3-4-3-7,3-16,
4-3,5-10, F-1
Index - 1