Texas Instruments 880 - Page 97

Received Line Signal Detector (CF) ............. 7-4
Standard Pitch
................................ 3-13,5-6
Request to
Send (CA) ............................... 7-4
Start Bit ................................................ 7-3
Reset Key
...................... 3-2,3-3,4-3-4-5, 7-6
Status Report .................. 3-2, 3-3, 3-4, 4-1, 5-6
Ribbon
................... 2-1,2-4-2-6, 4-5, B-1, F-2
STROBE- ........................................ 7-5, 7-6
Ribbon-Reversing Eyelet
........................... 2-4
ROMs ..................................... 3-13,4-3, E-1 T
Tab Set Key ..................................... 3-3,3-4
S
Test Indicator ............................. 2-7,4-1,4-2
Serial Interface .............. 1-1,2-8,2-9,3-12,4-3, Test Mode .......................... 3-1-3-4,4-1,4-2
4-5, 5-2, 5-3, 5-6, 7-1, E-1, F-2
TI Business Systems .......................... 2-8, A-1
Set Top of Form Key .......................... 3-3, 3-4 Tractor Locking Lever ......................... 2-5, 2-6
Seven-Bit Data
...................... 5-7,5-8,6-1, 7-3
Tractors
.................................... 2-5,2-6, F-1
Shift In (SI) ................................ 5-1,5-2, C-1 Transmitted Data (BA) ............................. 7-4
Shift Out (SO) ............................ 5-1,5-2, C-1
Signal Ground .................................. 7-5, 7-6
.U
Signal Ground (AB) ................................. 7-4 UART .................................................. 4-3
Single-Density Graphics
........................... 6-4
Single Pass Overstrikes ............................. 5-3 V
SLCT ............................................. 7-6, 7-8 Vertical Pitch .................................... 3-7,5-6
Slew Rate ............................................. F-1 VerticalTabs ......................... 3-1, 3-3, 3-4, 5-5
Index - 3