SWRU270
Page 11 of 28
Figure 14
4.2.2 Scanning for Devices
Press the “Scan” button under the “Discover / Connect” tab:
Figure 15
The USB Dongle will begin search for other BLE devices. As devices are found, the log on the left side of
the screen will display the devices discovered. After 10 seconds, the device discovery process will
complete, and the USB Dongle will stop scanning. A summary of all the scanned devices will be
displayed in the log window. In the example in Figure 16, one peripheral device was discovered while
scanning. If you do not want to wait through the full 10 seconds of scanning, the “Cancel” button can be
pressed alternatively, which will stop the device discovery process. The address of any scanned devices
will appear in the “Slave BDA” section of the “Link Control” section in the bottom right corner of the
sub-window.
To Next Page
Loading...
