Texas Instruments DP83869 - Configuration Options; Bootstrap Options; Figure 4-1. EVM Strap Jumpers; Table 4-1. 4 Level Straps

4 Configuration Options
4.1 Bootstrap Options
All straps are only two-level straps in DP83869 except PHYADD straps. EVM support one pullup and one
pulldown resistor pad on RX_D0 and RX_D2 for PHY address straps. There is only one pullup resistor on all
other strap pins with a jumper option to disconnect.
Table 4-1. 4 Level Straps
STRAP VALUE MODE 0 MODE 1 MODE 2 MODE 3
Resistor PU (kΩ) Open 10 5.76 2.49
Resistor PD (kΩ) Open 2.49 2.49 Open
Table 4-2. 2 Level Straps
STRAP VALUE MODE 0 MODE 1
Resistor PU (kΩ) Open 2.49
Resistor PD (kΩ) 2.49 Open
Figure 4-1. EVM Strap Jumpers
Configuration Options www.ti.com
10 DP83869 Evaluation Module SNLU237A – SEPTEMBER 2018 – REVISED JANUARY 2024
Submit Document Feedback
Copyright © 2024 Texas Instruments Incorporated