Need help?Do you have a question about the Texas Instruments DLP LightCrafter 4500 and is the answer not in the manual?
General| Brand | Texas Instruments |
|---|---|
| Model | DLP LightCrafter 4500 |
| Category | Motherboard |
| Language | English |
Introduces the DLP LightCrafter 4500 and the purpose of this guide.
Lists other relevant TI documents for the DLP LightCrafter 4500.
Directs users to TI E2E Community for help.
Introduces the EVM and its target applications.
Describes the light engine and driver board subsystems.
Lists parameters like brightness and power consumption.
Specifies thermal limits for LED currents.
Describes connection to PandaBoard ES.
Details and describes all external connectors on the module.
Explains the function of various jumpers on the board.
Step-by-step guide for powering up and connecting to a PC.
Introduces the GUI, operating modes, and basic controls.
Controls LED current and configures video input.
Details creating and managing pattern sequences.
Configures trigger signals and LED enable delays.
Steps to update the DLPC350 firmware via the GUI.
Covers packing images and building firmware.
Settings for clocks, PWM, and GPIO pins.
Explains bit-planes and RGB image composition.
Explains frame delay and trigger timing for sequences.
Table of combinations based on bit depth and rate.
How to apply saved .ini configuration files.
Instructions for editing .ini files directly.
Introduces the PandaBoard ES platform.
Describes connecting and configuring the PandaBoard for interface.
Details for input and output trigger connectors.
Pinouts for UART, I2C0, and I2C1 connectors.
Pinouts for LEDs, FPD-Link, JTAG, and power.
Highlights optical radiation, air circulation, and ESD risks.
Details voltage, current, and connector requirements.
Lists specific updates from previous revision.
Legal information on product use and warranties.
To Next Page
