2.2.3.2 USB-2-MDIO Software
Download the software from http://www.ti.com/tool/usb-2-mdio. The Web page also contains a User’s Guide for
installing and using the software.
The MSP430 is on board the EVM, so the user does not have to purchase a separate MSP430 Launchpad kit
and connect to the PHY using wires. The entire EVM can be powered and controlled through a USB connector.
MSP430 and USB2MDIO utility can be used even when power is not supplied through a USB.
In case the onboard MSP430 cannot be used due to some reason, MDIO and MDC pins are also broken out
on the J15 connector. Customers can connect a MSP430 launchpad or their own MDIO-MDC utility on J15 to
access the PHY registers.
www.ti.com Introduction
SNLU237A – SEPTEMBER 2018 – REVISED JANUARY 2024
Submit Document Feedback
DP83869 Evaluation Module 7
Copyright © 2024 Texas Instruments Incorporated
To Next Page
Loading...
