EasyManuals Logo

Texecom Veritas R8 Plus Installation Manual

Texecom Veritas R8 Plus
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Quick Reference and Factory Settings Veritas R8 Plus & Excel Installation Manual
6 INS045-14
Miscellaneous Options
Option Miscellaneous Selections Zero

Factory Setting
1 Cancel Strobe with Bell Off
2 Keypad PA (pressing
and
together causes PA alarm) Off
3 Single Button Setting On
4 Silent Part Set Confirmation Tone Off
5 EN 50131-1 Requirements Off
6 Time Limit Engineer Access Off
7 Reset Button Cancels Setting On
8 Automatically Omit a Mains Fail Condition (Auto-Omit AC Off) Off
Option Miscellaneous Selections One

Factory Setting
1 Internal Sounders Only on Unset Tamper Alarm On
2 Internal Sounders Only on Part Set Zone Alarm On
3 Internal Sounders Only on Part Set Tamper Alarm On
4 Silent Part Set (no exit tone on part set) Off
5 High Level Chime (chime at full volume) Off
6 Invert Bell Output (negative removed instead of negative applied, useful for SCBs) Off
7 Final Door Set (system sets 3 seconds after final door closure) Off
8 Unlock Engineer Code (re-loading factory settings restores default Engineer code) On
Option Miscellaneous Selections Two

Factory Setting
1 Engineer Reset on Any Alarm (see page 21) Off
2 Engineer Reset on Tamper Alarm (see page 21) Off
3 Disable User Ability to Omit Tamper Off
4 Code PIN Tamper (tamper alarm after 16 invalid key presses when unset) Off
5 Random Number Remote Reset (RNRR, see page 21) Off
6 Push To Set (see page 22) Off
7 Strobe Flash on Full Set (see page 21) On
8 Invert Switched Positive Output (off = negative removed, on = negative applied) Off
Option Miscellaneous Selections Three

Factory Setting
1 Mains Frequency (off = 50Hz, on = 60Hz) Off
2 EOL Tamper Alarm on Zone Short Circuit (S/C) Off
3 EOL Tamper Alarm on Zone Open Circuit (O/C) Off
4 Enable DD 243:2002 Options (see page 22) Off
5 Enable Confirmation Signal After Entry Time Out Off
6
Operation of a Keyswitch Zone is Momentary (Momentary KEYSW)
Off
7 Automatically Omit Zone on Alarm Off
8 Automatically Omit Keyswitch Zone when EOL Tampered Off
Option Communicator Selections

Factory Setting
1 Communicator Outputs Latch until System is Reset On
2 Line Monitor Input causes Tamper Alarm on Line Cut Off
3 Invert Communicator Outputs (off = active low, on = active high) Off
4 Invert Remote Reset Input (off = active if negative removed, on = active if negative applied) Off
5 Remote Reset Input Silences Internal Sounder during Alarm Off
6 Remote Reset Input Clears Engineer Reset (see page 21) Off
7 Silent PA Off
8 Enable 90 Second Abort Time Limit On

Table of Contents

Other manuals for Texecom Veritas R8 Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Texecom Veritas R8 Plus and is the answer not in the manual?

Texecom Veritas R8 Plus Specifications

General IconGeneral
BrandTexecom
ModelVeritas R8 Plus
CategoryControl Panel
LanguageEnglish

Related product manuals