EN
THREAD STAND
WINDING THE BOBBIN
1. Place a spool of thread onto the spool pin. Guide the
thread around the bobbin winder thread guide.
2. Insert the thread through one of holes in the bobbin
from the inside to the outside. Put the bobbin on the
bobbin winder spindle, and push it to the right. With
the free end of the thread held in your hand, depress
the foot control. When the bobbin is fully wound, it will
stop automatically.
3. Return the bobbin winder to its original position by
moving the spindle to the left, and cut the thread.
During winding the bobbin on the LCD will be shown:
The spool pins are used for holding the spool of thread in order to
feed thread to the machine.
To use, pull up the spool pin. Push down for storage.
1) Upper thread
2) Hole
3) Tangle
NOTE: In case of using the thread which has tendency to tangle
around the spool pin, thread through the hole of spool pin as
shown. The hole should face to the thread spool.
1
2
3
1
correct wrong
1
2
3
Texi Joy 4866
To Next Page
Loading...
Need help?
General
