13
ZT 200
Series
ENGINE COOLING
Continued operation with a clogged cooling system will
cause severe overheating and can result in engine
damage.
Perform the following steps daily or when fins become
clogged.
DAILY
1. Clean air intake screen S.
2. Clean oil cooler and radiator fins by opening latch
L and rotating screen S forward.
3. Wipe or brush off accumulated debris.
4. Unclamp and raise radiator by opening latch H.
Using compressed air, blow debris from fins
directing air away from the engine.
NOTE: Do not use pressurized water or other
liquid.
5. When completed, clamp the radiator and screen
back into place.
NOTE: Engine will not crank unless radiator is se-
curely clamped into place.
MAINTENANCE
To Next Page
Loading...
