15
ZT 200
Series
SYMPTOMS
Engine will not start.
PROBABLE CAUSE
Safety interlock not activated.
Battery discharged. (See
Page 8 for charging
instructions.)
SOLUTION
Latch clamps.
Shut off PTO.
Engage parking
brake or adjust
parking brake
switch.
Place levers in
neutral lock
position or adjust
traction control
switch.
Clean and tighten
cable terminal
fasteners.
Remove and
check charge
relay switching.
Replace relay if
necessary.
Repair as
necessary.
CHECK FOR
Radiator mounting clamp loose.
PTO Switch engaged.
Parking brake disengaged.
Position of traction control
levers.
Loose or corroded cable
terminals.
Charger relay function.
Electrical continuity.
Engine cranks but will
not start.
Cold ambient temp.
No fuel.
Fuel solenoid not activated.
Use glow plugs
per
recommendations.
Add clean fresh
fuel.
Direct lever toward
tank containing
fuel.
Purge air from fuel
line. (See decal
or Page 12.)
Check and tighten
all terminals as
required.
Check fuel
solenoid relay.
Replace relay if
necessary.
Replace fuse.
determine cause
for burned fuse
and repair as
required.
Glow plug chart. (See chart on
Page 23.)
No fuel in tanks.
Lever position of shut off/tank
select valve.
Air in fuel line. Air must be
purged from fuel line after
running out of fuel.
Electrical continuity. (Solenoid
should "click" when keyswitch
is turned on.)
Blown 30 Amp fuse.
TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
