Thermal Dynamics CE CutMaster 50

To Next Page

To Previous Page

WARNINGS

Read and understand this entire Manual and your employer’s safety practices before installing, oper-

ating, or servicing the equipment.

While the information contained in this Manual represents the Manufacturer's best judgement, the

Manufacturer assumes no liability for its use.

Plasma Cutting Power Supply

CE CutMaster™ 50

CE CutMaster™ 75

CE CutMaster™ 100

Operating Manual Number 0-2844

Published by:

Thermal Dynamics Corporation

82 Benning Street

West Lebanon, New Hampshire, USA 03784

(603) 298-5711

Thermal Dynamics Corporation

Reproduction of this work, in whole or in part, without written per-

mission of the publisher is prohibited.

The publisher does not assume and hereby disclaims any liability to

any party for any loss or damage caused by any error or omission in

this Manual, whether such error results from negligence, accident, or

any other cause.

Printed in the United States of America

Publication Date: March 22, 2004

Record the following information for Warranty purposes:

Where Purchased:_________________________________________

Purchase Date:____________________________________________

Model Number:____________________________________________

Power Supply Serial #:_____________________________________

Torch Serial #:_____________________________________________

Thermal Dynamics CE CutMaster 50 - Page 3