Need help?Do you have a question about the Thermal Dynamics CE CutMaster 80XL and is the answer not in the manual?
General| Output Current | 80 A |
|---|---|
| Open Circuit Voltage (OCV) | 300 VDC |
| Pilot Arc Current | 20 A |
| Duty Cycle | 60% |
| Cutting Capacity (Recommended) | 25mm (1") |
| Gas Type | Air |
| Dimensions | 23 x 10 x 20 in |
Highlights important information categorized as NOTE, CAUTION, and WARNING.
Covers hazards like electric shock, gases, fumes, noise, and arc rays.
Lists technical specifications like controls, indicators, power, and cut capacity.
Details how to connect the power supply to the electrical source.
Step-by-step guide for connecting the input power cable.
Details gas requirements and connection procedures for the plasma system.
Identifies and describes front panel controls and indicators.
Outlines the step-by-step procedure for operating the cutting system.
Details the setup steps required before operating the system.
Lists common issues and their potential causes and solutions.
Provides a guide for troubleshooting common system issues.
To Next Page
