Thermo Scientific HyPerforma DS 300 - Page 32

Figure 2.22. Inserting the
bearing port into the motor
mount
Note: When lining up the bearing port with the receiver of the
motor mount block, do not twist the BPC in the drum. Rotate the
drum and dolly, instead.
13. Ensure that the drain line and support collar are positioned
correctly in the drum, if applicable.
14. Remove the protective packaging from the lines at the top of the
BPC.
15. If your unit is equipped with the optional drum positioner, use it to
secure the drum and dolly in place with the supplied strap (Figure
2.23).
Figure 2.23. Securing
the drum and dolly to the
positioner with the strap
Thermo Scientific
Chapter 2 | Setup and operating information
HyPerforma DS 300 Single‑Use Mixer User's Guide | 29