Maintenance and Troubleshooting
On-Screen Warnings
Thermo Fisher Scientific Micro-Tech 9101/9201 Reference Manual, Rev J 4-23
While Measuring the Belt Length.
The Micro-Tech senses no speed-input signal.
1. Verify the speed sensor is rotating, there is no slippage, and the
Micro-Tech is receiving a proper input signal. If you are running the
Micro-Tech in the Simulated mode, verify the conveyor’s run
contact is providing input to the Micro-Tech.
2. Press the Continue button.
During certain set-up procedures, the user-configured safety interlocks
may be affected by changing certain parameters, such as the digital
input/output configurations.
Pulses detected.
Start belt.
EQUIPMENT MAY START
To Next Page
Loading...
