Thermo Scientific Micro-Tech 9201 - Page 186

B-14 Micro-Tech 9101/9201 Reference Manual, Rev J Thermo Fisher Scientific
Parameter
Selection
Description
Press Start to begin Weight
calibration
AUTO SPAN Weights
START, EXIT
Apply weights then press START
AUTO SPAN Weights
START, EXIT
Note: Only available if
LOAD WTS output was
selected in I/O Definition
Scroll.
Press START to load the test weights
AUTO SPAN Weights
START, EXIT
Run belt, then press START
Remove Weight before returning to
normal operation!
RUN, MENU
AUTOSPAN COMPLETE
EXIT, FACTOR, REPEAT
Note: Only available if
material calibration is done
before and the current
simulated load method has
no material factor installed.
Error %
Unfactored Calcon
XXXX Matl FACTOR
YES, NO, ADV
XXXX = R-CAL, CHAINS,
WTS
Note: Only available if
material calibration is done
before and the current
simulated load method has
no material factor installed.
New factor ____%
Change factor?
XXXX Matl FACTOR
RUN, MENU, REPEAT
XXXX = R-CAL, CHAINS,
WTS
Note: Only available if
material calibration is done
before and the current
simulated load method has
no material factor installed.
Old factor %
New factor %
MANUAL SPAN
EDIT, EXIT
Rate
Span #