Thermo Scientific Micro-Tech 9201 - Page 219

Thermo Fisher Scientific Micro-Tech 9101/9201 Reference Manual, Rev J B-47
No.
Parameter
Selection
Description
Low load
1
0 NO
1
Only available if load alarm is
defined in ALARMS DEFINE
scroll.
2
Only available if rate alarm is
defined in ALARMS DEFINE
scroll.
3
Only available if speed alarm is
defined in ALARMS DEFINE
scroll.
4
Only available when NTEP is
selected for W&M mode.
5
Only available if Loadout card
installed.
High rate
2
0 NO
Low rate
2
0 NO
High speed
3
0 NO
Low speed
3
0 NO
Totalizer
0 NO
Print ready
4
0 NO
Load WTS
0 NO
Dev. Alarms
4
0 NC
Out of range
4
0 NO
Zero Ready
0 NO
Fault
4 NC
Batch
5
0 NO
8
Remote counter
pulse div.
1 ton (0.01 - 100)
Note: Only present when
Totalizer output is defined.
9
Remote counter
pulse width
0.100 sec (0.005 - 1)
Note: Only present when
Totalizer output is defined.
10
Type board 1
8in8out
Source, Sink
11
Type board 2
8in8out
Source, Sink
12
Clip detect mode
Manual, Auto
13
Clip detect length
1.0 ft (0.5-10)