Thermo Scientific TSQ Quantum XLS and TSQ Quantum GC Preinstallation Requirements Guide 25
Installation
Prior to having your TSQ Quantum XLS or TSQ Quantum GC system installed, make sure
to complete all preparations described in the previous chapters.
After you have completed your laboratory site preparation, mailed or faxed the TSQ
Quantum XLS or TSQ Quantum GC Installation Request Form, and received the system,
call your Thermo Fisher Scientific office to set up an installation date. See the Installation
Request Form at the front of this guide. Telephone and fax numbers for Thermo Fisher
Scientific San Jose offices are listed in the preface of this guide and immediately following the
Installation Request Form. Table 11 summarizes information about installing your system
and indicates where you will find additional details.
Table 11. Summary of the installation process for your system (Sheet 1 of 2)
Page
Preinstallation Survey
Complete the Installation Request Form at the front of this guide, and fax or
mail it to your local service representative before the service engineer arrives to
install your system.
26
Installation Kits
To install your system, the Thermo Fisher Scientific service engineer uses the
kits supplied with the TSQ Quantum XLS or TSQ Quantum GC system.
To complete the installation of your system, the service engineer might need
additional parts and chemicals.
27
Installation
The Thermo Fisher Scientific service engineer completes the installation of
your system and demonstrates that it meets specifications. Do not plan to use
your system before the engineer has demonstrated that the system operates
within specifications.
28
To Next Page
Loading...
Need help?
General
