Think city - Changing the Windshield Wiper and Key Fob Battery

5. Service and Maintenance
519
Changing the Windshield Wiper and Key Fob Battery
Checking and Changing the Windshield Wiper
If the wiper does not clean properly, try washing the wiper
blade and windshield with washer uid and rinse with clear
water. If this does not help, the wiper may be worn and must be
replaced.
The wiper can be bought at service stations, auto parts stores
and from your THINK NA dealer.
NOTE: The wiper can only be lied slightly up from the
windshield – do not try to bend it out further.
Pull the wiper blade and arm up and away from the glass.
Remove the blade and install a new blade (refer to instructions
on the package).
Test the wiper before driving.
Adjusting the Wiper Spray Duct
The washer spray duct is located
on the wiper arm. This can be
adjusted with a needle – stick it
into the spray duct and turn to
the desired angle. Test that the
spray squirts the windshield at
the correct spot, remembering
that the speed of the vehicle will
aect the spray.
Changing the Battery in the Key Fob
1. Use a small screwdriver to separate the remote control
from the actual key.
2. The remote control can be opened up by pressing the
locking arms carefully away (one on each side).
3. Place the positive (+) side
of the battery in the same
direction (see diagram
on inside of remote
control).
4. Put the transmitter
together again. It is not
necessary to reprogram
the transmitter aer
changing the battery, it
should work as before.
+
—