26
1. Start engine, with the throttle in idle
position (T90075).
2. Engage the front hydraulic jack, raise
the front of machine to the travel posi-
tion (T90113).
3. Back tow vehicle under unit, engage the
king pin to the tow vehicle fifth wheel
(T90077).
4. Connect both gladhand connection and
the plug for the electrical harness from
the tow vehicle to the unit (T90074).
5. Rotate the suspension dump valve to the
"Raised Position" or CW (clockwise)
1/4 of a turn; rear of unit will raise as
tow vehicle air system charges with
units air system (T90075).
If Toggle switch is used on unit; switch
suspension dump valve to the "Up
Position" or to the left; rear of unit will
raise as tow vehicle air system charges
with units air system.
6. Remove axle stop control pin, move
lever to travel position, reinstall safety
pin (T90057 & T90011).
7. Engage the front hydraulic jack so the
units landing gear is in the retracted
position (T90114).
3. OPERATION
T90074
Front hydraulic jack
T90113
T90077
T90011
Operating position
T90057
T90072
Gladhands
Electrical
Travel position
T90114
Set up at idle speed
T90075
Dump valve
Safety pin
To Next Page
Loading...