3. OPERATION
3.6 TRANSPORTING
Before transporting the machine, per-
form the following checks:
Tire pressure 120 PSI (830 kPa). Wheel
nuts torque 500 - 550 ft/lbs (680-748 Nm).
Check the wheel nut torque and tire pres-
sure again after 50 hours. Check before
moving to another site each time (T90024).
Check axle hub oil level. The oil
should be level with the check plug.
The machine is equipped with a pneu-
matic brake system. For safety, if the
machine disconnects from the tow vehicle,
the emergency brakes will engage (actuate
automatically). Check to be sure the axle
lock machansim is in the transporting posi-
tion (T90057).
Verify that the clearance marker indica-
tor lights are all functioning. Repair imme-
diately if defective.
Clean any debris from the screen that
may be left after use. This may prevent
debris from falling out while transporting
the machine and damaging other motorists.
If product is lodged in wire cloth, remove
the affected screens from the machine.
WARNING
25
Check wheels, tires and axle grease
T90024
Check wheel nut torque
T90057
Do not transport this machine without the
braking system functioning properly.
WARNING
To Next Page
Loading...