THOMSON 512392 - Configuration Using a Web Browser

www.thomsonsecurity.eu
17
EN
EN
MOTORISED 720P HD WIFI IP CAMERA
D - CONFIGURATION AND USE
1
Tick "Yes" to activate movement detection
then click "Sauvegarder [Save]" to display the
area grid on the image.
2
Sensitivity: On "élevée [high]", the smallest
movement on the screen triggers an alert. On
"minimum", only the largest objects trigger
alerts (for example, a person, but not a dead
leaf in the camera's  eld of vision). Adjust
to suit the camera's  eld of vision and the
desired objective.
3
Trigger interval: pause between alerts if
motion is detected over an extended period
4
Detection area: The camera feed appears
behind a grid. If motion is detected in a red
box, an alert is triggered. If motion is detected
in a blank box, no alert is given. Click on
boxes to activate them (red) or deactivate
them (blank), for example, so as not to focus
on a window and to prevent anything on the
outside from being unnecessarily triggered.
IMPORTANT: When you have  nished the
con guration, remember to click on "Save" at the
top of the screen to save everything you entered.
This completes the con guration. From now on, any
movement in front of the camera in the areas and
at the times you speci ed triggers an email alert.
3 - CONFIGURATION USING A WEB BROWSER
Warning: frequent policy changes made by the
main web browser developers as well as the
number of possible con gurations and versions can
make it tricky to con gure your camera. If possible,
it is preferable to use a smartphone, tablet or
dedicated software.
• Use the "IP camera tool" software, which can
be downloaded from our website.
* http://www.thomsonsecurity.eu/docs.
php?lang=FR&type=5&ref=512392
• This will detect your camera on the network
and show its IP address.
• Double-click on its name to open the camera
con guration in your web browser.
Your browser will need an additional module to
display the image from your camera correctly and
will ask you if you want to install it. Accept the
request to allow your browser to display the image:
Note: Depending on which browser you are using,
the procedure may differ but the principle remains
the same: you must permanently allow the module
to run if you want your camera to work properly in
your browser.
For more information, refer to our advanced guide
available on our website:
http://www.thomsonsecurity.eu/docs/pdf/512390-
512391-512392-512393-tutoriel-v3_03.pdf