MEC 2 MICROPROCESSOR ENGINE/GENERATOR CONTROLLER
PM056 Rev 6 05/10/15 Thomson Technology
60
9.4.5. TRANSIENT DELAY TIMES
This allows the selected fault circuit to be inhibited from being activated until the
specified time delay period has expired. Delay times from 0.0 to 999.9 seconds
are available by entering the time required.
9.5. DIGITAL FAULT PROGRAMMING MENU
To program the controller’s digital fault circuits, refer to the following descriptions.
9.5.1. DIGITAL FAULT LABEL
To select the desired fault label description, use the INCREMENT key to scroll
through the available labels. The digital fault labels are stored in non-volatile
memory and are as follows:
AIR DAMPER TRIPPED HIGH OIL TEMP
BAT CHARGER INPUT FAIL HIGH WINDING TEMP
BAT CHRG TROUBLE LOW COOLANT LEVEL
BREAKER TRIPPED LOW ENGINE TEMP
DC FAIL LOW FUEL LEVEL
FAILED TO SYNC LOW FUEL PRESS
GEN BREAKER OPEN LOW OIL LEVEL
GROUND FAULT LOW OIL PRESSURE
HIGH BEARING TEMP REMOTE EMERG.STOP
HIGH COOLER VIBRATION REVERSE POWER
HIGH ENGINE TEMP BASIN RUPTURE
HIGH ENGINE VIBRATION ATS IN BYPASS
HIGH FUEL LEVEL FUEL LEAK
HIGH OIL LEVEL LOW FUEL PRESS
NO LOAD TEST BAT CHARGER FAIL
*HIGHINTKMANFTEMP
VENT DAMPER FAIL
HIGH FUEL LEVEL
FAIL TO SYNC
“Blank” (i.e. no text for unused inputs)
Once the desired fault label is selected, press the ENTER key to accept the
selection.
To Next Page
Loading...
