Receiver Descrambler - User Manual (release 7.3.1)
BISS Setup
To setup the unit to be able to decrypt a BISS encrypted transport stream use the following steps:
1. Press the
button to bring the display back to the RDS
status screen.
2. Press the
button to access the RDS 1 Menu.
3. Use the
and
buttons to move the cursor to “BISS
Decryption,” then press the
button.
4. Press the
button again to edit the Source ID settings.
Note: To configure dual units, all of the following instructions apply exactly the same except, use the
button to access the RDS 2 Menu.
5. Use the
and
buttons to move the cursor to “Mode:”
then press the
button.
6. Use the
and
buttons to change the mode (“BISS 1”
or “BISS E”) then press the
button to save the selection.
Note: Depending on the mode selection, the menus below the mode options will have changed.
Mode BISS 1
Once the unit has been set to use Mode 1, use the following steps to enter the “Session Word:”
1. Use the
and
buttons to move the cursor to
“Session Word” then press the
button.
2. Use the
and
buttons to select the column to edit
and use the
and
buttons to enter the session
word, then press the
button to save the selection.
Mode BISS E
Once the unit has been set to use Mode E, use the following steps to enter the “Encrypted Session
Word” and “Injected ID:”
1. Use the
and
buttons to move the cursor to
“Encrypt Session Word” then press the
button.
2. Use the
and
buttons to select the column to edit
and use the
and
buttons to enter the encrypted
session word, then press the
button to save the
selection.
BISS RDS 1
Mode:BISS E
►Encrypt Session Word
0x0000000000000000
BISS RDS 1
Mode:BISS 1
►Session Word
0x000000000000
BISS RDS 1
►Mode:BISS 1
Session Word
RDS 1 ←→
Audio 2 Setup
Source ID
►BISS Decryption
To Next Page
Loading...
