THOMSON RD1002 - Page 53

THOMSON RD1000 / RD1002
Page 53
Receiver Descrambler - User Manual (release 7.3.1)
Edition 2 – October 2010
Edit/Remove an IP
Note: Existing IP addresses are shown before the “Add IP” option.
1. Use the and buttons to move the cursor to
the desired IP address to edit, then press the
button.
2. Use the and buttons to select either “Edit” or
“Remove”, then press the button.
Clear All
This option will clear all IP addresses in the filter list.
1. Use the and buttons to move the cursor to
“Clear All”, then press the button.
2. Press the button one more time to clear all the IP
addresses in the list.
Receive 2
This section allows the user to setup the receive function of the second receive group.
1. Use the and buttons to move the cursor to
“Receive 1” then press the button.
2. Use the and buttons to move the cursor to
“Receive:” then press the button.
3. Use the and buttons to “Enable” or “Disable”
Receive 1, then press the button to save the
selection.
4. Use the and buttons to move the cursor to “Phys
Conn:” then press the button.
5. Choose the physical connector using the and
buttons (“Port 1” or “Port 2”) then press the button.
 MPEG/IP 1-4 2 
Receive:Enable
►Phys Conn:Port 1
Ip:239.192.0.1
 MPEG/IP 1-4 2 
►Receive:Enable
Phys Conn:Port 1
Ip:239.192.0.1
 MPEG/IP 1-4 
Timeout:0.5s
Receive 1
►Receive 2
 MPEG/IP 1-4 1 
239.192.20.3
Add IP
►Clear All
 MPEG/IP 1-4 1 ←→
Filter Mode:Include
Edit Remove
Add IP
 MPEG/IP 1-4 1 
►239.192.20.3
Add IP
Clear All