Receiver Descrambler - User Manual (release 7.3.1)
Synchronized Source Setup Filter
1. Use the and buttons to move the cursor to
“SSRC Filt:” then press the button.
2. Use the and buttons to select the column to edit
and use the and buttons to change the SSRC
Filter, then press the button to save the selection.
Buffer
1. Use the and buttons to move the cursor to “Buffer:”
then press the button.
2. Use the and buttons to select the column to edit and
use the and buttons to change the Buffer (from 3999
kb to 100 kb), then press the button to save the
selection.
IGMP V3 Source Filter
Note: Any emitter can send IP packets to a multicast address, so it could happen that by mistake
two emitters send to the same multicast address. The resultant multicast stream would be
completely garbled. IGMP V3 gives the user the possibility to indicate a source address, so
that by indicating "IGMP V3 include <IP multicast source address> the unit will take only the
IP packets coming from the indicated source address, thus eliminating the garbling problem.
Alternately, if the offending source address is known, the user can indicate "IGMP V3 exclude
<IP multicast source address of the scrambler>, and the unit will not take into account IP
packets coming from the indicated address.
To not use the IGMP V3 filter, simply select "IGMP V3 exclude" and do not indicate any IP
address to exclude.
Beware if you select "IGMP V3 include" and you do not indicate the multicast source address
the unit will receive nothing.
1. Use the and buttons to move the cursor to
“IGMP V3 Src Filter”, then press the button to access
the Edit screen.
MPEG/IP 1-4 2
SSRC Filt:0x00000000
Buffer:0100kb
►IGMP V3 Src Filter
MPEG/IP 1-4 2 ←→
SSRC Filt:0x00000000
►Buffer:0100kb
IGMP V3 Src Filter
MPEG/IP 1-4 2 ←→
FEC:Disable
SSRC:Disable
►SSRC Filt:0x00000000
To Next Page
Loading...
