THOMSON SpeedTouch 585 - Configuring WDS

Chapter 4
SpeedTouch™ Web Interface
E-DOC-CTC-20050429-0103 v1.0
95
4.6.6 Configuring WDS
What is WDS The Wireless Distribution System (WDS) allows you to extend the range of your
wireless network by introducing one or more WDS-enabled devices into your wireless
network.
Accessing the WDS
page
To access the WDS pages on the SpeedTouch™:
1 On the left menu, click Home Network.
2 Under Wireless, click the Access Point you want to configure for WDS.
3 Click Configure.
4 Under Pick a task... list, click Configure WDS.
SpeedTouch™
configuration
Proceed as follow:
1 Under Pick a task..., click Scan for wireless accesspoints.
2 The SpeedTouch™ prompts you that all associated stations will loose
connectivity for a few seconds. Click OK.
3 The SpeedTouch™ lists the results in the Accessible Access Points table.
4 Select the Access Point to which you want to establish a WDS connection.
5 Click Apply.
6 Configure this Access Point with:
 The same WEP key if WEP is enabled.
 The same fixed channel.
!
You can only establish WDS links with WDS enabled devices.
The Access Points names are of the following format: “WLAN: “ +
Network Name, for example “WLAN: SpeedTouch123456.