Chapter 2
Local Network Setup
E-DOC-CTC-20050429-0103 v1.0
30
Registering clients via
association button
You can easily register new wireless network clients as follows:
Push the Association / on the SpeedTouch™front panel for at least two
seconds. The WLAN LED will toggle between green and red.
The ACL will be unlocked for a time frame of one minute. Any new wireless
client successfully attempting to connect to the SpeedTouch™ (having the
correct wireless settings, that is the network name and, if required, the
network key) within the time frame of one minute, will be added to the table.
The SpeedTouch™ automatically saves your current configuration at the end of
the registration phase.
1 Successfully registered stations are associated to the SpeedTouch™ WLAN.
Depending on your WLAN client adapter, a wireless icon may become green or
a message similar to the following may appear: “Successfully joined Wireless
network SpeedTouch123456”.
2 The wireless clients will be added to the SpeedTouch™ ACL.
3 After one minute the ACL is locked.
Some WLAN clients do not automatically join a WLAN. If so, follow
the instructions for the WLAN client software to initiate the
association.
The registration procedure can be repeated as often as needed.
To Next Page
Loading...
