2.5 Installing the batteries
Fig. 4
Open the cover on the remote control and insert 2x AAA batteries into the
compartment. Correct position of the polar diagram shows the batteries inside the
compartment.
1. Open the cover.
2. Insert the batteries.
3. Close the lid.
WARNING: The batteries should not be recharged, disassembled, electrically
short-circuited, be mixed or used with other types of batteries.
2.6 Using the remote control
Fig. 5
To use the remote control, point it towards the front of your receiver. The remote
control supports a range of up to5meters distance to the receiver at an angle of up to
approx. 30 degrees.
NOTE: Managing the receiver will be limited or not possible if there are
obstacles between the remote control sensor (at the front panel
of the receiver) and the remote control. Direct sunlight or very
bright light can reduce or disturb the reception of the remote
control signals.
3.0 CONNECTION
3.1 Connecting to cable TV
Fig. 6
Connect your receiver to the wall connector provided by your cable operator, using a
high quality coaxial cable (75 Ohms). Normally, wall connections could be either F-type
or IEC male type. Use a cable with suitable connectors. This receiver has an IEC female
input.
3.2 Connecting to TV with HDMI cable
Fig. 6
The TV set shall be connected with the receiver using a good quality HDMI cable. This
connection gives the highest possible quality.
To Next Page
Loading...
