P24
TROUBLESHOOTING
pressing the YELLOW/2 button. Select Off to deactivate
Timeshift.
Step to: 30 sec to 30 min. Set the time step you like to jump forward
to by pressing 4 during playback of recorded files. This only
works when the info banner is displayed on screen. If it is not,
press INFO.
Time Shift to Record: If set to On the timeshifted part will be included in your
recording when you start to record the current programme.
PS Record: Select between On or Off. When Off is selected, recordings will
also include subtitles and Teletext (when available). Record to
PS mode On allows recordings without these extras and will
need less space on your USB device.
Press EXIT to leave this menu.
*This user manual describes the full functionality including the recording function and may not be applicable if the
PVR software has not yet been installed.
7.5.4 Remove USB device safely
Select Remove USB device safely from the tools menu and press OK. The receiver will
display a message indicating that you can safely remove your storage device from the
receiver.
NOTE: After performing this function, the USB device is no longer
accessible from your receiver. To gain access to your storage
device again, re-insert it or switch the receiver to standby and
on again.
8.0 TROUBLESHOOTING
There may be various reasons for abnormal operation of the receiver. Check the
receiver according to the procedures shown below. If the receiver does not work
properly after checking it, please contact your dealer or the local Service Hotline. Do
NOT try to open or disassemble the receiver. It may cause a dangerous situation and
warranty will be void.
Problem Possible cause What to do
LED indicator not lit Mains lead unplugged Check mains plug
No signal found Cable input is
disconnected
Check cable lead
Check with dealer
To Next Page
Loading...
