• To ensure best performance of your USB storage device please format it via your
receiver (through the menu “Media”) to FAT32 system. Other file systems are not
supported by the receiver. However, it is possible to use already NTFS formatted disks.
• THOMSON cannot guarantee compatibility with all types of USB storage devices.
• If you are going to use external USB HDDs (Hard Disk Drives), please consider that
power specifications may exceed the supported output of your receiver (max. 5 V/800
mA). If so, please connect your USB HDD to an according external power adapter.
• It is advised not to store important information on USB storage devices used with the
receiver. Always make backups of data on your USB storage device before using it
with this receiver. THOMSON will not take responsibility for any loss of information or
circumstances caused by loss of information.
*This user manual describes the full functionality including the recording function and may not be applicable if the
PVR software has not yet been installed.
2.0 YOUR RECEIVER
2.1 DEFAULT PIN: 1234
2.2 Front Panel
Fig. 1
1. IR sensor Point your remote control towards this sensor.
2. Display Indicates current time in STANDBY mode or current channel
number in OPERATING mode
3. Mode indicator RED indicates that the receiver is in STANDBY mode.
GREEN indicates that the receiver is in OPERATING mode.
4. USB Connector for USB storage devices.
2.3 Rear Panel
Fig. 2
1. CABLE IN Connect your receiver to the wall connector provided by the
cable operator
2. CABLE OUT Connect your receiver to another digital receiver or to a TV
to keep using its internal (analogue) tuner (loop through
function)
3. S/PDIF COAX. Connect your receiver to a digital home theatre, AV receiver
or digital audio amplifier.
4. HDMI Connect your receiver with your TV set using an HDMI cable.
5. TV SCART Connect your receiver with your TV set using a SCART cable.
6. Power cord Your receiver requires a supply voltage of 220~240V AC (Auto-
selectable), 50/60Hz ±5%. Please ensure the local power
To Next Page
Loading...
