This part of the wizard is of great help when setting up your antenna system.
Use pq to move the highlight to the setting you wish to alter and use tu to change values.
The following settings are available:
Antenna Power: Set to On if you use an active antenna. When set to On, 5 V will be present at
the ANT IN connector of the receiver. Select Off for passive antennas.
Beeper: Select On for an audible indication of signal reception. Off turns the beeper off.
Channel No.: Select a channel that is known to carry a broadcast in your region. The Signal
Strength and Signal Quality bars give a visual indication of the reception.
Adjust your antenna to obtain maximum signal strength and quality.
When all settings have been made, press OK to start scanning.
The receiver will search for all available channels now. Once scanning is finished, the receiver
switches to viewing mode.
TIP: If the Welcome menu does not appear after switching on the receiver the first
time, reset the receiver to factory settings by pressing the MENU button and
selecting Load Factory Setting in the submenu Tools. (DEFAULT PIN: 1234).
5.0 QUICK GUIDE TO USING YOUR RECEIVER
We at THOMSON understand that you can’t wait to enjoy your new high definition digital
terrestrial receiver. The following quick guide will make you familiar with the basic operation of
this device. We do, however, advice you to read the full user manual to get the best performance
from your receiver.
To turn your receiver ON or to Standby, use the q button on the remote control.
Choose a channel with the pq buttons. Alternatively, you can digit the channel number with the
0~9 buttons on the remote control or press OK in viewing mode to display the channel list. The
volume can be adjusted with the tu buttons.
6.0 OPERATION
Your new receiver is equipped with several features to make watching TV a true pleasure. This
paragraph describes these features. Please also read chapter 7.0 to get familiar with the menu of
your receiver.
6.1 Changing channels
Following ways are possible for changing channels with your new receiver:
• Via direct access using the 0~9 buttons.
• Via the channel list using OK and the PG+/PG- buttons.
• Via the pq buttons.
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply input its number with the 0~9 buttons on the
remote control. Channel numbers can be up to four digits long. Entering a number with less than
four digits is possible. Just wait a few seconds and your receiver will switch to the selected channel
or press OK immediately after selecting the channel number.
To Next Page
Loading...
