P18
MAIN MENU
7.4.3 S/W Upgrade by OTA
This receiver is equipped with an Over The Air software upgrade function. An Over The Air update
might not be available in your region. Please visit our website www.thomsonstb.net or contact
your local service hotline for more information about this option.
7.4.4 Upgrade by USB
This feature allows you to upgrade receiver software via the USB port. When new software is
available for your receiver, it can be downloaded from our website www.thomsonstb.net.
Place the software file (unzipped) in the root directory of your USB storage device (HDD, memory
stick etc.) and connect the device to the USB port of the receiver.
Select Upgrade by USB from the Tools menu and press OK to proceed.
The upgrade menu will now be displayed.
Use pq to select Upgrade Mode and choose option Allcode.
Use pq to select Upgrade File and choose the file containing the latest and correct software.
When all settings have been made, move the highlight to Start and press OK to start the upgrade
process.
After a few seconds, the receiver asks: “Are you sure to burn flash?”. Select Yes to finalize the
upgrade or No to quit without upgrading.
NOTE: If, after a software upgrade, the receiver should behave in an unexpected way,
please perform a factory reset as well. See chapter 7.4.2.
WARNING: After an update the receiver restarts automatically. During the upgrade process
NEVER disconnect the receiver from the mains or switch off the power! Doing
so might damage your receiver and will void warranty!
7.4.5 Channel Dump and Load function
This feature allows you to load a channels list quickly and use a channel list that previously was
created on this (backup) or another receiver from the same model via the USB port. This is useful
when more receivers have to be installed in the same region, thus omitting a full scan and
(optional) sorting of channels. It is also useful as a backup for your own unit.
Channel Dump function (backup to USB)
Have a storage device connected to the USB port of the receiver. Select Upgrade by USB from the
Tools menu and press OK to proceed. The upgrade menu will now be displayed.
Use pq to select Update Mode and choose the option Dump channel list.
Use pq to select Upgrade File. A DataBase file name containing date and time will be presented,
format DBYYYYMMDDHHMM (DateBaseYearMonthDateHourMinute.udf).
Use pq to select Start and press OK to proceed. The channel list and favourites will be saved.
To Next Page
Loading...
