EasyManua.ls Logo

THOMSON THT504+ - Troubleshooting and Specifications; Remove USB Device Safely; Troubleshooting Common Problems

THOMSON THT504+
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
P22
TROUBLESHOOTING
PS Record: Select between On or Off. When Off is selected, recordings will also include
subtitles and Teletext (when available). Record to PS mode On allows
recordings without these extras and will need less space on your USB device.
Press EXIT to leave this menu.
7.6.4 Remove USB device safely
Select Remove USB device safely from the tools menu and press OK. The receiver will display a
message indicating that you can safely remove your storage device from the receiver.
NOTE: After performing this function, the USB device is no longer accessible from your
receiver. To gain access to your storage device again, re-insert it or switch the
receiver to standby and on again.
8.0 TROUBLESHOOTING
There may be various reasons for abnormal operation of the receiver. Check the receiver according
to the procedures shown below. If the receiver does not work properly after checking it, please
contact your dealer or the local Service Hotline. Do NOT try to open or disassemble the receiver. It
may cause a dangerous situation and warranty will be void.
Problem Possible cause What to do
LED indicator not lit Mains lead unplugged Check mains plug
No signal found Aerial is disconnected
Aerial is damaged/
misaligned
Out of digital signal area
Active antenna requires to
switch ON antenna power/
external power
Check aerial lead
Check aerial
Check with dealer
Switch receiver’s Antenna Power
ON/connect external power
No picture or sound
on TV or amplifier
HDMI or SCART is not
selected on your TV or
amplifier or the unit is set to
higher resolution as the TV
supports.
TV/amplifier is not switched
on
Switch to correct TV/amplifier
input
Select lower resolution on
receiver
Switch TV/amplifier on.
Check if S / PDIF connection
is used.
Scrambled channel
message
Channel is scrambled Select alternative channel
No response to remote
control
Receiver off
Remote not aimed correctly
Front panel obstructed
Remote batteries exhausted
Plug in and turn on plug
Aim remote at front panel
Check for obstructions
Replace remote batteries

Related product manuals