P14
MAIN MENU
7.1.4 Rename Favourite list
This menu allows you to personalize the names of the 8 available favourite lists.
Use pq to select Rename Favourite List from the Edit Channel Menu and press OK to proceed. The
names of all groups are now displayed. Select a favourite group with pq and press OK to edit
its name. A text field will now pop up at the right of the screen. Use tu pq to select characters
and enter them with OK. When you have finished editing, press BLUE to save the changes. When
all changes have been made, press EXIT twice to leave this menu.
7.2 Installation
7.2.1 Auto Scan
Use pq to select Installation and press OK or u to advance.
Select Auto Scan with pq and press OK to enter.
Use tu to toggle between Yes or No. When FTA Only is set to Yes, scrambled channels won’t be
stored in the channel list. Use pq to highlight Search. Now press OK to start auto scan.
The receiver will store all found channels in the channel list.
7.2.2 Channel Scan
Use pq to select Installation, press OK or u to advance.
Use pq to select Channel Scan and press OK to enter.
Use tu to toggle between available scan modes: By Channel and By Frequency.
If By Channel is selected, use the cursor buttons to select Scan Band and Channel No. If By Frequency
is selected, use the cursor buttons to select Frequency and Bandwidth. Highlight Search and press
OK to start scanning. Newly found channels will be added to the channel list.
7.2.3 Antenna Power
Use pq to select Installation, press OK or u to advance.
Use pq to select Antenna Power and press OK to enter.
Set to On if you use an active antenna.
Select Off for passive antennas.
When set to On, 5 V will be present on the ANT IN connector of the receiver.
Press EXIT to leave the Antenna Power menu.
7.2.4 LCN (Logical Channel Numbering)
If LCN (Logical Channel Numbering) is activated and an LCN signal is provided by the operator,
channels will be stored in an operator defined order. Set LCN to On to activate operator defined
channel numbering or Off to store channels in found order. This function only applies when a new
channel search is performed.
To Next Page
Loading...
